Pumps
  Tubing Pumps
      Flowmaster
      ECOLINE
      MCP / BVP
      REGLO
      IP / IPC
      MS/CA
  Gear Pumps
  Piston Pumps
  OEM Panel Mounted
>SUBMIT YOUR SPECS
>New Catalog
- Download
- Printed catalog

Tubing

Accessories

Downloads

   About ISMATEC
   Find Distributor
   Technology
   What's New




Ismatec is part of the product
line of IDEX Health & Science.
For further information about
IDEX Health & Science see
www.idex-hs.com
 
MCP Process

MCP-Process (drive)

Drive without pump-head
Operating panel
Operating panel MCP-Process
> Operating Manual (PDF)
PC-programmable
dispensing pump system
IP65-rated 
"washdown" drive
Ordering Information
Order No. for this drive
ISM 915
Interchangeable pump-heads
Click one of the buttons and choose your pump-head ...
Link to single-channel pump-heads
Link to multi-channel pump-heads
 
Flow rates < 0.001 – 3700 ml/min (depending on mounted pump-head)
Channels 1 24 (depending on mounted pump-head)
Operating panel- 7-button membrane key-pad
- LED display
Memory4 sets of operating parameters can be stored
Programming
(similar to PLC)
4 individual command sequences programmed in a PC can be stored in  the pump. The user can run the programs using the pump as a stand-alone unit.
Operating modes

- pumping by drive speed (rpm)
- pumping by flow rate (ml/min)
- factory-set flow rates for all available tube sizes
- dispensing by volume (ml)
- dispensing by time (0.1s up to 999hrs)
- dispensing by volume within a pre-set time
- interval dispensing by volume with a pause
- interval dispensing by time with a pause
- setting the number of dispensing cycles
- pause time setting (from 0.1s up to 999hrs)
- roller back-steps for drip-free dispensing

- reversible rotation direction

Calibrating function- for flow rate (ml/min)
- for dispensing volume (ml)
Speed 1 240 rpm
Speed setting rpm, resolution 0.1 rpm
Speed controlclosed loop control for pressure independent speed
RS232 interfaces- RS232 "in"   - for operation controlling via PC
- RS232 "out" - for cascading up to 8 pumps
Analog inputSpeed control (05 or 010V / 020 or 420mA)
Analog outputSpeed monitoring (010VDC or 07.2 kHz)
Digital input (TTL level)Start/Stop, rotation direction, autostart, 2 universal inputs
Digital output (PWM)2 universal outputs
Differential pressure 1.5 bar (21.7 psi) possible (depending on pump-head and tubing material); small tubing diameters may allow higher pressures
Motor typeDC motor
Power consumption100 W
Power supply 100 – 230 VAC / 50 – 60 Hz
Protection ratingIP 65
Depth / Width / Height220 x 155 x 260 mm (8 2/3" x 6 1/10" x 10 ") (without pump-head)
Weight6.9 kg (16 lb) (without pump-head)
Accessories - Progedit software (free download)
- Driver for "LabView" software (free download)

- Foot switch
Overview MCP/BVP pump series


IDEX Health & Science GmbH, Futtererstr. 16, 97877 Wertheim, Germany
www.ismatec.com, CustomerService.hsEurope@idexcorp.com, Inquiry form, Phone and fax numbers